Some details about my “Corvus Pro Rom”

September 30, 2025 · First shared in the Apple II Enthusiasts Facebook group

Some details about my “Corvus Pro Rom”
These are the physical floppy disks that I still have for my Corvus drives. The top 6 were all produced by Corvus. The bottom 2 were configuration disks that went with my custom firmware for the Corvus Apple II parallel interface card. The first side of the pro master was a bootable DOS 3.3 disk that allowed you to configure the custom firmware. You told it the total number of 512 byte blocks your Corvus hard disk had, and how many 50 track DOS 3.3 Volumes you wanted on the DOS partition. That config information got written to the first block of the hard disk. The backside of the floppy was a bootable ProDOS disk that you used for setting up the ProDOS partition. With my firmware you always booted to ProDOS, and then if you wanted to access the DOS 3.3 partition, you executed either “-DOS.3.3”, or “-DIVERSI.DOS” from the ProDOS volume.
The information stored on the hard drive was in this order: config block, ProDOS volume, DOS 3.3 volumes.
I supported two Corvus drives per controller card. So with a controller in slot 7 for example, I had S7D1 (5 MB), and S7D2 (10 MB), back when the 5 MB worked.
I had two Apple II parallel interface cards back when I ran my BBS, so both my dev machine and my BBS machine could share the 5 MB drive. The BBS was running on the DOS volumes, and I did most of my work on the ProDOS volume.
Many years later when I stored my //e in the crawl space, one of the two Corvus parallel interface cards got trashed along with my original //e motherboard.
Moist crawl spaces and old computers don’t mix well.
https://www.facebook.com/share/p/19vv6t1mzu/

The physical Corvus floppies that I still have.

The physical Corvus floppies that I still have.

The front side of my “Corvus Pro Rom Master” (tm) 😆

The front side of my “Corvus Pro Rom Master” (tm) 😆

The back side of the same disk.

The back side of the same disk.

A book that helped me to figure out how to get my 50 track DOS 3.3 volumes working

A book that helped me to figure out how to get my 50 track DOS 3.3 volumes working

Tags: corvus, prodos, hardware